Scale Remover No. 1
SCALE REMOVER No. 1 is a highly-concentrated, acid-based scale remover. It is fast-acting and non-fuming. It also contains patented corrosion inhibitors. Concentrated liquid weighs approximately 13 lbs per gallon. It has no hydrochloric (muriatic) or other acids for safe use and dissolves twice the amount of scale.
Features and Benefits
- Safe for Use on Copper
- Corrosion Inhibited
- No Hydrochloric Acid
- Two Times the Scale Removal
Part Number; Size
- SR1-1 1 gallon 4/cs
- SR1-5 5 gallons
Directions:
- Drain and flush recirculating system.
- Remove all loose debris. Clade bleed-off valve where applicable.
- Fill the system with fresh water.
- Add 1 gallon of Scale Remover No. 1 for every 20 gallons of water.
- Allow for water in the piping.
- Circulate solution until the scale is removed or acid is spent.
- One pH indicator strip will show when the acid solution is neutralized.
- In badly scaled systems, use one or more additional dosages. To repeat dosage, add more Scale Remover No. 1 in the same 20 to 1 ratio, then bleed enough water from the system to compensate for the added remover.
Repeat steps 1 through 3. If still another dosage is required, drain the system completely before proceeding. Do not use more than 2 doses with the same water. Clean system. Thoroughly flush the system before refilling with fresh water. Adjust the bleed-off valve as necessary.
DANGERS & PRECAUTIONS:
Read and understand the product’s label and Safety Data Sheet. It causes severe burns of eyes, skin, nose, throat, and lungs. May be harmful if inhaled or swallowed. Do not mix with chlorine type bleaches or other household chemicals. Keep out of reach of children. Provide sufficient mechanical ventilation. Wear chemical-resistant gloves such as neoprene or rubber. Chemical splash goggles and a face shield are advised. Do not mix with any products.
