MAGNA TACK
MAGNA TACK is a high strength adhesive specially formulated to bond fiberglass insulations, urethane, rubber sheet, duct board, and bubble foil type insulation to sheet metal. It creates both permanent and temporary bonds on many surfaces. Excellent for porous or uneven surfaces as well as smooth surfaces. Waterproof, flexible, transparent, non-staining adhesive sets quickly. Effectively bonds other surfaces such as labels, cartons, floor tile, cloth, carpet, ceramic, glass, wood, Formica, leather, plastics, foam, etc. Cleans up with mineral spirits.
Aerosol (MTA-1) is LOW VOC and MIR 50 State Compliant.
Features and Benefits
- Bonds fiberglass, urethane, rubber sheet, duct board, and bubble foil to sheet metal
- Wide web spray
- Extremely Versatile
- Permanent/temp bonds
- Cleans with mineral spirits
Part Number; Size
- MTA-1 12 oz aerosol 12/cs
- MT-LC Large 35LB cylinder
- MTAR-SC Small 15LB cylinder (REMOVER)
Red
- MR-1 1 gal 4/cs
- MR-5 5 gallons
- MR-55 55 gallons
Black
- MB-1 1 gal 4/cs
- MB-5 5 gallons
- MB-55 55 gallons
UL Listed Red
- UMR-1 1 gal 4/cs
- UMR-5 5 gallons
- UMR-55 55 gallons
UL Listed Black
- UMB-1 1 gal 4/cs
- UMB-5 5 gallons
- UMB-55 55 gallons
DIRECTIONS:
AEROSOL DIRECTIONS:
- Shake well before using the product.
- Remove cap.
- Point opening in the desired direction.
- Hold container 8 to 12 inches from surface to be sprayed.
- Press button to spray. For best results, apply adhesive using a side to side spraying motion.
For temporary bonds, apply to surface and allow tack to tack. Apply the material to be bonded. For permanent bonds, apply to both surfaces to be joined. Allow to tack and then press together. After use, invert can and spray until the tip is clear to prevent clogging. If adhesive accumulates around opening in spray nozzle, wipe clear while wet. If the opening becomes clogged, remove with degreasing solvent.
GALLON DIRECTIONS:
- Spray, brush, or roll inside of sheet with a light coat of adhesive.
- Apply a slightly thicker coat around the edges to provide enough wet strength for a good bond.
- You can also spray a light coat on both the insulation and the metal to use the adhesive as a contact cement.
DANGERS & PRECAUTIONS
Read and understand the product’s label and Safety Data Sheet. Extremely Flammable Aerosol Contains gas under pressure: May explode if heated. Causes skin and eye irritation. Suspected of damaging fertility or the unborn child. May cause drowsiness or dizziness. Damage to the central nervous system may happen through prolonged or repeated exposure. If the product is swallowed or enters airways it may be fatal. Keep out of reach of children. Keep away from heat sources such as sparks, open flames, and hot surfaces. No smoking around this product. Do not spray on an open flame or other ignition sources. Pressurized container. Do not expose to temperatures exceeding 50C/ 122F. Wash hands thoroughly after handling. Wear protective gloves and eye protection.
